Water Heater Repair







Understanding Drain line cleaning Idaho Falls




Should a problem occur or our technician detect a problem with the p-trap or plumbing drain line (household sewer system), he or she will recommend the services of a licensed plumber. In our opinion, blowing out a large diameter plumbing drain line is not and effective repair. The household sewer system, beginning at the open connection to the condensate system, is the domain of the licensed plumber.


Liabilities- Whenever the air handling unit of an air conditioning system is located in an attic or the upper stories of a building, the risk of water damage due to drain stoppage and condensate overflow is inherent and unavoidable. Proper design and installation coupled with timely and consistent maintenance can minimize the probability of an overflow, but cannot absolutely prevent it. Therefore, our warranties specifically exclude liability for water damage due to condensate overflow, and special, consequential or incidental damage caused by stoppage of a condensate drain system.







Other measures our technician my recommend are the installation of a float switch in the emergency condensate drain pan and an Easy Klear clean out valve. Should both the primary and emergency drain systems fail, the float switch functions to turn off the air conditioning system, stopping the production of condensate until the clog is cleared and the drain pan emptied. The Easy Klear helps improve drain line maintenance.


Despite all of these precautions, there can be no guarantee that your condensate drain system will remain clear. Your condensate drain system can become clogged at anytime and should be watched closely after it has been serviced, especially when algicide has been applied. Older systems with accumulations of algae can become clogged anytime algae breaks loose from the pipe wall and drifts downstream to a restricted point. At a restriction, algae will accumulate and grow unit it blocks the drain pipe. These restrictions can grow into a fully clogged drain line in less than one month.






The primary condensate drain lines normally drains into the household sewer system through an open connection to an active p-trap. In some cases, these active p-traps are the bath tub or bathroom sink p-trap; should this be your case, be sure to read the special instructions in maintenance, below. Should the evaporator coil's primary drain line become clogged or should the primary drain develop a leak, condensate should overflow or leak into the emergency drain pan thence into the emergency drain line. The emergency condensate drain line, drain line, drains to a conspicuous place outside the home. Water dripping from the emergency drain line is a warning indicator that something is drastically wrong with primary condensate drain system. You should not delay in calling a service technician.get more info



Problems- With primary condensate drain lines stem form plant pollen, fungus spores and other particulate matter entrained in the air stream passing over the wet evaporator coil. They are captured by the condensate draining off the coil and are carried into the drain system. There they produce algae, mildew, and fungus growths which can clog the primary drain system. While the emergency drain lines are normally dry and clear, they are open to the atmosphere. Wasps, called "mud-daubers", are known to nest in these open drain lines, there by rendering them useless; always at the wrong time.


The larger diameter pipe of the household sewer system yields two results. First, it usually precludes problems with condensate. Second, the maintenance and repair beyond the open connection to the p-trap is outside the scope of the air conditioning technician. Some older systems drain into an inactive p-trap; this can lead to the long term build up of sediment, dried algae, etc... in the trap and result in an overflow of the plumbing drain system. If the active p-trap also services a bath tub or bathroom sink, clogs can be caused by hair, soap scum or other material draining from the tub or sink. Clogs in the household sewer system require the services of a licensed plumber.


Maintenance- Test both the primary and emergency drains with water. If a restriction is detected, he or she clears the obstruction with compressed air. Blowing out a drain line will usually open a clogged drain line, but it cannot remove growing algae or other deposits from the pipe wall. Our technician will place algicide tablets in the primary drain pan. While algicide is used prevent algae buildup, algicide kills any existing algae. The dead algae may slough off the pipe wall and pass into the sewer system or drift down stream to a restriction and accumulate there resulting in a clogged drain.


Special Instructions- Bathtub or bathroom sink p-traps. If the active p-trap in your system is the trap for a bath tub or bathroom sink, there is the possibility that material flushed from the condensate drain system may combine with bathroom debris already in the trap, to begin formation of a clog. Should one of these plumbing drains clog, condensate will fill the sink or tub and overflow without any warning such as water dripping form the emergency drain line. After any work on your condensate drain system, the drainage of the sink and tub should be observed. If either drains slowly or backs up, plumbing maintenance is needed.

Detailed Notes On water heater repair Idaho Falls




Water heater problems are normally self-evident, either the water does not become hot or it starts to leak or makes strange gurgling noise. These problems are commonly found in every household. But most revolve around the same symptoms and can be handled or repaired by you. Knowing the basic water heater repairs can help you a lot in your day to day life. It is quite an easy way to resolve these issues.water heater replacement Idaho Falls is an excellent resource for this.

There are a variety of problems which can be faced while using a water heater for a long duration. If your heater is not providing you with sufficient hot water supply, then the first thought that come in mind is whether the heater is getting the required power to heat the water. Sometimes there might be a scenario where the exhaust valve gets jammed, the valve opens when the temperature in the tank is higher than its limit and hence releases the pressure within. If the valve is clogged for a long time there is a risk of the heater exploding. Valves can be easily cleaned, and you don't need a plumber for that. If you check the valve in regular intervals of time, it will help the water heater to become durable and safer. If you are at all suspicious about the mechanism of valves, getting it replaced as soon as possible is the best option.

Sometimes a situation is seen where steam or boiling water comes from the valve, or we hear rumbling sounds. In such cases, shutting the heater off at once is the best solution to avoid any kind of problems. Water leakage is also a reason of improper functioning of water heater, hence keeping a timely check on the leakage can also help to maintain its proper operation. Sometimes in the long run sediments get accumulated inside the heater unit because of regular use of the heating mechanism. Thus clearing out the water or flushing can help. These minor repairs make the heater quite durable and also controls the damage which can be caused due to negligence.

The second most encountered problem in water heaters is the anode rod. It is the device that protects the inside of the heater by following the process of electrolysis. This is an important process which helps the unit to become long lasting. Because if the decomposition of the rod stops it causes the decomposition of the interior lining. So if the rod is dissolved to an extent where it does not perform the task properly, it has to be replaced. If you are familiar with replacement then it can be done at home otherwise it is suggested that an electrician or a professional is called to do the replacement work. Knowing the basic water heater repairs might prove useful.

There are also instances when we monitor that the heater starts taking a longer time to provide hot water. It is primarily because of the build up of lime elements. If you are supplied with hard water, this can be the reason of delay. We can either use water softener or clean the heating parts regularly to avoid such problem. Cleaning can be done by disassembling the heating parts, soaking them in vinegar and then removing or scratching the accumulation.